0.5 Micron Oxygenation Wand Complete Kit

NOW WITH 0.5 MICRON STONE BY POPULAR DEMAND FOR MAXIMUM O2 UPTAKE

Achieving the proper level of dissolved oxygen in wort is one of the most important factors in a successful fermentation. Something as simple to acheive as good oxygenation/aeration before pitching your yeast can make a massive difefrence to yeast health and viability. This in turn leads to complete, fast and healthy fermentations, which can transform your brews!

Oxygenating your wort before adding yeast can transform your beer!

For a single batch - for example 20L at 1.048 SG at 18°C, you would want around 8ppm minimum to 12ppm of oxygen. Shaking the fermenter vigorously will get you only to 8pmm at the most, and quite likely it will be much lower than this.
However, with pure oxygen and the 0.5 Micron Wand, you will oxygenate at a flow rate of at least 1L per minute for 60 seconds!

General rules of thumb:
Medium strength worts (Above 1.060): 8-12ppm ~ Flow Rate: 1L per minute for 60 seconds per 20L.

Lager yeast strains: 10-14ppm ~ Flow Rate 1L per min for 120 seconds per 20L

Strong worts (1.100 and above): 14ppm ~ Flow Rate 1L per min for 120 seconds per 20L
Plus a second dose of 14 ppm 12-18 hours after the yeast is pitched (the time required for at least one cell division to have occurred)

How to get started:
Boil your air stone for a few minutes and sanitise the attached wand with Ethyl Sanitiser Spray 70% Medical Grade Ethanol + Distilled Water (1litre Spray Bottle) 32oz
Open the regulator to release the oxygen slowly. 
Dial in on the flow meter to 1L per minute.
Once you have achieved this, submerge the wand to the lowest part of your fermenter.
Start your timer and keep a close eye for bubbles breaking on the surface of your wort.
If they are, then you may need to oxygenate a little bit longer and/or decrease flow rate.
Once done remove the wand with the gas still on.
Once removed from the liquid close the valve on the regulator
Rinse and boil the air stone to keep it clean and sanitary.

Avoid touching the stone with bare hands. The oils in your hands can clog up the tiny pores on the stone.

Safety Message
Please be very careful when using pure oxygen. It is highly flammable and if ignited will burn furiously. It should go without saying, but please don’t use it anywhere near a naked flame (or any other kind of flame for that matter)

This kit bundle includes:
1 x KL25324 3.3L Oxygen Disposable Gas Cylinder (O2)
1 x KL02165 Regulator for Oxygen - M12 Thread
1 x KL06880 duotight – 8mm (5/16”) Female x FFL Female Thread (to fit Regulator)
1 x KL13185 Oxygen flow meter Including duotight - 8mm (5/16) x FFL
1 x KL39055 0.5 Micron Oxygenation / Aeration Wand Kit with screwlock duotight Elbow
1 x KL24631 duotight - 8mm (5/16) Screwlock x 8mm (5/16) Elbow
1 x KL18012 Rigid Plastic Joiner 6mm ID x 8mm OD (5/16) x 50mm Long

Also available as a Complete Oxygenation Wand Kit with a 2 micron stone
0.5 micron stones are recommended for faster uptake of O2 in the wort, however they are more prone to clogging if mishandled.
2 microns stones will not work as efficiently, but are slightly easier to manage.

Shipping prices are calculated on the checkout page based on the size, weight, and where it needs to be delivered. You can be confident that you will receive accurate and fair shipping rates specifically tailored to suit your individual purchase. 

Once an order is placed, please note that KegLand is unable to make changes or additions to the order or modify the shipping information. If any changes are required, it is the customer's responsibility to directly contact the shipping provider and arrange for redirection or any necessary adjustments. 

Read More: Shipping Policy